Electrolux EFME627UTT Wiring Diagram English - Page 1
Electrolux EFME627UTT Manual
View all Electrolux EFME627UTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
This information is intended for Qualified Technicians Only. Table of Contents Dryer Tech Data Sheet 1 Diagnostic Mode Tests/Demo Mode 2 Dryer Error Codes 3 Wiring Diagrams 10 Push Button Cycle Select Dryer User Interface Dryer Tech Data Sheet 1 Safety items throughout this manual are labeled with a WARNING or CAUTION based on the risk type as described below: This symbol alerts you to situations that may WARNING cause serious body harm, death or property damage. CAUTION This symbol alerts you to situations that may cause bodily injury or property damage. CAUTION Unless otherwise directed, disconnect electrical current before servicing. 1 2 3 Rotary Dial Cycle Select Dryer User Interface 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10 1 power 2 cycle status display 3 cycle selector 4 temperature 5 dryness (dry level) 6 time dry (dry time) 7 options 8 select (set) 9 cancel 10 start / pause Entering Diagnostic Mode: 1. Press power and look for console light up. 2. Rotate cycle selector ring (on some models) or repeatedly press cycle button (on other models) to set cycle to normal. 3. Press the start button. 4. Power off machine by pressing the power button. 5. Power on machine by pressing the power button again. 6. Within 10 seconds, simultaneously hold temp + select (set) buttons together for 3 seconds. 7. Diagnostic Mode is active when LED's start blinking in sequence. This is the pre-test position " ", which tests the lights and buttons. 8. Press the start button. Scrolling through Diagnostic Mode tests: Tests are selected by using the same method to select cycles. See Diagnostic Mode Tests Table. For push button cycle select dryer: Press and hold the cycle button for 2 seconds. The unit will advance to the first test; and flash " " on the display. Press the cycle button to advance to the following test. Press the temp button to go back to the previous test. For rotary dial cycle select dryer: Use knob to advance to the first test by rotating clockwise. Turn knob counterclockwise to navigate previous tests. Test sequence numbers are briefly displayed when each test is selected. The displayed test numbers also correspond to the selector LEDs to the right of the numeric display; beginning with the top LED, following downward. Exiting Diagnostic Mode: Hold the power key for 3 sec, when not in " Lights/Buttons, or unplug the unit. " test step A11199903 (1901) USA 1-877-435-3287 www.electroluxappliances.com Canada 1-800-265-8352