Electrolux EI23BC30KB Complete Owner's Guide (English) - Page 11

Removing the Doors 11 Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out Drawer Assembly Fully Extend Drawer Slides Pin Slot Cabinet 2 Reinstall four (4) drawer screws (two (2) per side), tighten down, and close drawer (C). A B 6 Tighten four (4) drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place. Install Screws (2) Each Side 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.