Electrolux EI23BC35KB Complete Owner's Guide (English) - Page 32

32 Care and Cleaning Care and cleaning tips Part Interior & Door Liners Door Gaskets Drawers & Bins Glass Shelves Toe Grille Exterior & Handles Cleaning Agents • Soap and water • Baking soda and water • Soap and water • Soap and water • Soap and water • Glass cleaner • Mild liquid sprays • Soap and water • Mild liquid sprays • Vacuum • Soap and water Exterior & Handles (Stainless Steel Models Only) • Non abrasive glass cleaner • Soap and water • Stainless steel cleaners Tips and Precautions • Use two (2) tablespoons of baking soda in one (1) quart of warm water. • Be sure to wring excess water out of sponge or cloth before cleaning around controls, light bulb or any electrical part. • Wipe gaskets with a clean soft cloth. • Use a soft cloth to clean drawer runners and tracks. • Do not wash any removable items (bins, drawers, etc.) in dishwasher. • Allow glass to warm to room temperature before immersing in warm water. Sudden temperature changes can cause glass breakage. • Remove toe grille (see Installation Instructions). • Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry. • Do not use commercial household cleaners containing ammonia, bleach or alcohol to clean handles. • Use a soft cloth to clean smooth handles. • Do not use a dry cloth to clean smooth doors. • Never use CHLORIDE or cleaners with bleach to clean stainless steel. • Clean stainless steel front and handles with non-abrasive soapy water and a dishcloth. Rinse with clean water and a soft cloth. • Use a non-abrasive stainless steel cleaner. These cleaners can be purchased at most home improvement or major department stores. Always follow manufacturer's instruction. Do not use household cleaners containing ammonia or bleach. • NOTE: Always clean, wipe and dry with grain to prevent scratching. • Wash the rest of the cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. Ice Chute Extension The ice chute extension is designed to better direct ice flow into containers. Removing the Ice Chute Extension For Cleaning 1 Turn the refrigerator off using the button on the control panel (refer to Owner's Manual). 2 Press inward firmly on the front of the chute and pull down. Press Here Firmly 3 Turn your refrigerator back on. Installing the Ice Chute Extension 1 Turn the refrigerator off using the button on the control panel (refer to Owner's Manual). 2 Align the extension with the ice chute so that the snap clips are just inside the front edge of the chute. Push Upward Until The Extension Snaps In Place 3 Push upward until the extension snaps into place. 4 Turn your refrigerator back on. Pull Down