Electrolux EI23BC37SS Complete Owner s Guide English - Page 7

CAUTION Do Not loosen or remove these 3 hex screws. Installation 7 4 After unit is leveled, lower anti-tip leg using a 3/8 inch socket wrench until it firmly contacts the floor. DO NOT Loosen or Remove These 3 Hex Screws Door Door Anti-tip Leg Raise Lower Cabinet Leveling & Refrigerator Door Alignment (if necessary) Guidelines for final positioning of your refrigerator: • All four corners of the cabinet must rest firmly on the floor. • The front should be slightly elevated to ensure that doors close and seal properly. • Doors should align with each other and be level. Most of these conditions can be met by raising or lowering the adjustable front rollers. To level the cabinet using the front rollers: 1 Slightly open freezer drawer if the toe grill is installed. Lift the toe grille and gently pull forward. 2 Make initial cabinet adjustments by using the front roller height adjusting screws. Use a 3/8 inch socket wrench to turn the adjustment screws (1 per side). To raise: turn adjustment screw clockwise. To lower: turn adjustment screw counterclockwise. 3 Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable. 5 Install the toe grille by fitting into place. Toe Grille Must Fit in Slot on Anti-tip Bracket Screw/Washer Assembly (3) Retaining Clips To make final door height adjustments: 1. Open freezer drawer to make lower hinge visible. 2. Insert 6mm Allen wrench into the shaft of the lower hinge. 3. Adjust the height by turning clockwise or counterclockwise. Turning clockwise will lower the door. Turning counterclockwise will raise the door. Default setting is to the lowest height when you receive your appliance. Raise