Electrolux EI23BC65KS Complete Owner's Guide (English) - Page 7
Freezer Drawer Alignment, Cabinet Leveling & Refrigerator, Door Alignment
View all Electrolux EI23BC65KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installation 7 Freezer Drawer Alignment (if necessary) 1 Check gasket seal around top, bottom, and sides of freezer drawer. 2 If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate. 3 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. To level the cabinet using the front rollers: 1 Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration). 2 You can raise or lower each door. Use a 3/8 inch socket wrench to turn the adjustment screws (1 per side). 4 Tighten four (4) drawer screws. 5 Recheck gasket seal. To raise: turn adjustment screw clockwise. To lower: turn adjustment screw counterclockwise. 3 Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable. 4 After unit is leveled, lower anti-tip leg until it contacts the floor. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out Door Door A B Cabinet Leveling & Refrigerator Door Alignment (if necessary) Guidelines for final positioning of your refrigerator: • All four corners of the cabinet must rest firmly on the floor. • The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly). • Doors should align with each other and be level. Most of these conditions can be met by raising or lowering the adjustable front rollers. Anti-tip Leg Raise Lower 5 Install the toe grille by fitting into place.