Electrolux EI30EW48TS Complete Owner s Guide English - Page 11
Before Setting Oven Controls, Oven Vents, Oven Racks, Types of Oven Racks
View all Electrolux EI30EW48TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Before Setting Oven Controls 11 BEFORE SETTING OVEN CONTROLS Oven Vents The oven vent is located under the control panel of the upper oven, and above the door handle of the lower oven. When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block oven vent. Steam or moisture may appear near the oven vent. This is normal. Types of Oven Racks Flat Oven Rack Flat oven racks (or the flat handle oven rack) may be used for most cooking needs and may be placed in most oven rack positions. Oven Vent Warm Air Figure 2: Flat oven rack and flat handle oven rack Oven Vent Warm Air Always use potholders or oven mitts when removing food or adjusting the oven racks. Wait until the oven in completely cooled if possible. Oven racks may be very hot and may cause burns. Figure 1: Oven vent locations IMPORTANT! Some models are equipped with a cooling fan that runs during the cooking process to cool internal electronic components. It is normal for this fan to continue to run for an extended period of time, even when the oven is off. Oven Racks Do not line the oven walls, racks, bottom, or any other part of the oven with aluminum foil. Doing so will alter heat distribution, produce poor baking results, and may cause permanent damage to the oven interior. During self clean temperatures, the oven will be hot enough to melt foil. IMPORTANT! All racks and the ladder racks supports should be removed before a self clean. Racks left in during a self clean may discolor and become harder to ooperate.To remove the ladder rack support for a self clean cycle, reverse the order used when installing the ladder rack supports. Always remove/replace the oven racks before turning on the oven (when the oven is cool). IMPORTANT! To prevent possible damage to the oven, do not attempt to close the oven door until all the oven racks are fully positioned back inside the oven cavity. Clean oven racks according to the instructions provided in the Care & Cleaning section. Arranging, Removing, and Replacing Flat or Offset Oven Racks • To Arrange: Always arrange the oven racks when the oven is cool (prior to operating the oven). • To Remove: Pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. • To Replace: Place the oven rack on the rack guides on the oven walls. Tilt the front of the rack upward slightly and slide the oven rack back into place. The Luxury-Glide™ rack has a locking mechanism that operates differently than flat racks. See instructions on next page for installing and removing glide rack.