Electrolux EI30EW48TS Complete Owner s Guide English - Page 43
Self Clean Problems, Questions or for service call: 1-877-4 ELECTROLUX 1-877-435-3287
View all Electrolux EI30EW48TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
before you call 43 Self Clean Problems Problem Solution Self Clean does not work or is performing poorly Review steps for "Read Before Starting Self Clean:" beginning on page 33. Perform the following check: Press Broil; Press START. Place your hand near the handle on the oven door. Between the door and the control panel you should feel a rush of air on your hand. If so, your unit is functioning properly and you have had a Power Failure in your home. If no air stream is present, call a service technician to replace your cooling fan. Soil not completely removed after self clean. Self clean was interrupted. Review instructions on "Self Clean"on page 33. Excessive spills on oven bottom. Remove excessive spills before starting self clean. Failure to clean soil from the oven frame, the door liner outside the oven door gasket, and the small area at the front center of the oven bottom. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket. Questions or for service call: 1-877-4 ELECTROLUX (1-877-435-3287)