Electrolux ELFW7537AT Complete Owners Guide English - Page 29

29 CONTROLS AND SETTINGS • Chocolate Stain wash time is extended with additional heating by boost heater. StainSoak (600 series washer) Similar to StainTreatII above with the added feature of detergent/treatment mixing with SmartBoost pump technology before the Stain washing phase. perfect steamTM (on select models) Select this option to add approximately 20 minutes of tumbling in steam.  NOTE • Steam may not necessarily be visible inside drum during a steam wash cycle. • Steam may not be present during entire steam wash cycle. IMPORTANT • If steam is selected, rinse temperatures will be elevated. • If the wash cycle is paused or cancelled during a steam cycle, the door will remain locked until it cools. You may manually perform a rinse & spin cycle to cool the internal temperature sooner. • During a steam cycle, steam exiting from the rear vent of the washer is normal and not cause for alarm. Wash cycle options extra rinse (on select models) Use this option when additional rinsing is desired to remove excess dirt and detergent. It is recommended for heavily soiled loads or if household members have sensitive skin. pure rinse (on select models) Use this option to reduce detergent residues and fragrances that can irritate skin which rinses cleaner than the extra rinse cycle. wrinkle release (on select models) After the final spin, the washer will perform a "dry" agitation to loosen the garments from the side of the drum. extended refresh (on select models) Select extended refresh if you will be unable to remove the load right after the cycle is complete. The washer recognizes the load has sat too long and will do a rinse and spin to keep the load fresh for up to 12 hours. When you are ready to remove the load during the extended refresh segment, you must press cancel to end the cycle and open the door. PODS® (on select models) Select this option when using a detergent pack in a model equipped with a PODS® button (on select dispenser only). This option will divert the flow of water to the detergent pack compartment optimizing the detergent pack performance. Control options control lock To lock the controls between cycles, scroll to the control lock option and press select. The control lock icon will show on the LED display. To unlock the controls scroll to the control lock option again and press select. Use this feature to reduce the likelihood of accidental operation by children. Washer cycles will not run when control lock is activated. delay time Use delay time to delay the start of the washing cycle from 30 minutes to 12 hours. To turn on the delay time option, press options to scroll to the delay time icon and press select. Use the cycles button (300/400 models) or turn the cycle selector (500/600 models) to select the desired delay time and press start. The delay time icon will illuminate on the LED display to indicate the delay time option is activated. The time will begin counting down on the LED display once the washer start/pause button has been pressed. PODS® is a registered trademark of Procter & Gamble Company, Cincinnati OH, used under license by Electrolux.