Electrolux EW23BC85KS Complete Owner's Guide (English) - Page 12

12 Removing the Doors NOTE You will be pulling approximately five (5) feet of water tube from the back of the refrigerator. 4 Unscrew the three (3) lower hinge screws and hinge if necessary. To reinstall the right door, reverse the above steps. Lower Hinge Removal Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. Drawer Assembly Fully Extend Drawer Slides Pin Slot Cabinet Once both doors are in place, ensure they are aligned with each other and level (Please see the Installation section for more details), and replace the top hinge cover. NOTE When reinserting the water tube and replacing the top hinge cover, use care to be sure you do not kink the tube. 2 Reinstall four (4) drawer screws (two (2) per side), tighten down, and close drawer (C). CAUTION Be sure doors are set aside in a secure position where they cannot fall and cause personal injury, or damage to the doors or handles. Removing Freezer Drawer 1 Open freezer drawer. 2 Remove drawer screws on right and left sides (two (2) screws on each side). 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out CAUTION Drawer is heavy. Use caution when lifting. 3 Lift drawer up and out to remove. A B 6 Tighten four (4) drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place.