Electrolux EW30WD55QS Installation Instructions (All Languages)
Electrolux EW30WD55QS Manual
View all Electrolux EW30WD55QS manuals
Add to My Manuals
Save this manual to your list of manuals |
Electrolux EW30WD55QS manual content summary:
- Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 1
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Canada INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS support 200 pounds. (90,7 Kg) Bottom of oven cutout B F Warm and Serve Drawer A Warm - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 2
Spirit Level Warm & Serve Drawer Installation 1.Locate drawer as instructed in the Use & Care Guide and secure drawer instructions provided with built-in oven. Make sure to use anti-tip brackets supplied with the built-in oven. Disconnect electrical supply cord from wall receptacle before servicing - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 3
your Warm & Serve Drawer. Combination Warm & Serve Drawer and Cooktop Installation Cooktop Cutout Serial Plate Location Warmer Drawer Cutout You can install the warmer drawer in combination with an electric or gas cooktop. You must follow the specifications from the installation instructions of - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 4
INSTRUCCIONES DE Instalación PARA EL Cajón CALENTADOR Canadá LA INSTALACIÓN Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. Estados Unidos - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 5
frontal del cajón esté a ras contra el gabinete. Tenga cuidado de no pinchar el cable eléctrico. 3. Remover el cajón como indica el manual de uso y cuidado asegure el marco contra el gabinete utilizando los tornillos niquelados (vea la Figura 2). No apriete demasiado los tornillos. 4. El cable de - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 6
INSTRUCCIONES DE Instalación PARA EL Cajón CALENTADOR Ubicación de la placa de serie Encontrará el número de serie y modelo impresos en la placa de serie. Cuando pida componentes o desee obtener informaciones sobre su cajón calentador, asegúrese de incluir el modelo y el número de serie o una letra - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 7
ET LE SERVICE. IMPORTANT: CONSERVEZ CES INSTRUCTIONS POUR LES INSPECTEURS LOCAUX. LISEZ CES INSTRUCTIONS ET CONSERVEZ‑ l'arrière à l'avant. combiné à un four encastré superposé. La surface doit pouvoir supporter 100 lbs (45,4 Kg). Dimensions du tiroir-réchaud NOTE: Un câble de 60" (152 - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 8
Scie à main ou scie sauteuse Niveau à bulle Installation d'un tiroir-réchaud 1. Localisez les supports anti-bascule tel qu'indiqué à la fig. 1. c/c 25 5/16" (64,3 cm au tiroir-réchaud (s'il y a lieu). Suivez les instructions d'installation fournies avec le four encastré. Assurez-vous d'utiliser - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 9
INSTRUCTIONS D'INSTALLATION POUR LE TIROIR-RÉCHAUD Emplacement des numéros de modèle et de série La plaque signalétique est située tel que montré plus - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 10
NOTES - NOTAS 10 - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 11
NOTES - NOTAS 11 - Electrolux EW30WD55QS | Installation Instructions (All Languages) - Page 12
NOTES - NOTAS 12
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
Combination Warm & Serve Drawer/ 27" (68,6 cm) or
30" (76,2 cm) Built-in Oven Installation
D
A
F
E
C
B
P/N 318201809 (0901) Rev. D
English – pages 1-3; Español – páginas 4-6
Français – pages 7-9; Notes - pages 10-12
Warm & Serve Drawer Dimensions
Stand Alone Installation
NOTE:
A 60" (152,4 cm) long cable is supplied with
the Warm & Serve Drawer.
FLOOR
Warm and Serve
Cutout
Warm and Serve
Drawer
60" (152,4 cm)
Cord
Minimum distance to floor
4½" (11,4 cm)
IMPORTANT:
The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
H*
= 11 7/8" (30,2 cm) Min.
is a Critical
dimension and has to be respected
.
Bottom of oven cutout
Caution
: Two 3" (7,6 cm) wide X
3/4" (1,9 cm) thick planks have to
be install and they should be able to
support 200 pounds. (90,7 Kg)
Printed in the USA
J**
= 3" (7,6 cm) Max.
Electrical Junction Box for wall oven must be
lower than warmer drawer cutout.
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11 ¼" (28,6 cm
)
27" (68,6 cm)
23
3
/
8
" (59,4 cm)
30" Models
11 ¼" (28,6 cm
)
30" (76,2 cm)
23
3
/
8
" (59,4 cm)
D. CUTOUT
HEIGHT
E. CUTOUT
WIDTH
F.
CUTOUT
DEPTH
27" Models - Min.
9
7
/
8
" (25,1 cm)
25 ½" (64,8 cm)
23
5
/
8
" (60 cm)
Max.
10 ¼" (26 cm)
25 ¾" (65,4 cm)
24" (61 cm)
30" Models - Min.
9
7
/
8
" (25,1 cm)
28 ½" (72,4 cm)
23
5
/
8
" (60 cm)
Max.
10 ¼" (26 cm)
28 ¾" (73 cm)
24" (61 cm)
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11 ¼" (28,6 cm
)
27" (68,6 cm)
23
3
/
8
" (59,4 cm)
30" Models
11 ¼" (28,6 cm
)
30" (76,2 cm)
23
3
/
8
" (59,4 cm)
D. CUTOUT
HEIGHT
E. CUTOUT
WIDTH
F.
CUTOUT
DEPTH
G. HEIGHT
27" - Min.
9
7
/
8
" (25,1 cm)
25 ½" (64,8 cm)
23
5
/
8
" (60 cm)
2" (5,1 cm)
Max.
10 ¼" (26 cm
)
25 ¾" (65,4 cm)
24" (61 cm)
Depends on critical
dimension H
30" - Min.
9
7
/
8
" (25,1 cm)
28 ½" (72,4 cm)
23
5
/
8
" (60 cm)
2" (5,1 cm)
Max.
10 ¼" (26 cm
)
28 ¾" (73 cm)
24" (61 cm)
Depends on critical
dimension H
GENERAL INFORMATION
: The Warm & Serve Drawer
can be used as a stand alone appliance or combine with a
built-in oven mounted above.
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
FOR YOUR SAFETY:
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
Canada
United States
IMPORTANT:
The warmer drawer must be installed on
a leveled surface from left to right, rear to front and the
surface must be capable of supporting 100 lbs (45,4 Kg).