Electrolux EW30WD55QS Installation Instructions (All Languages) - Page 2
Important Safety, Instructions
View all Electrolux EW30WD55QS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions for future reference. IMPORTANT SAFETY INSTRUCTIONS • Be sure your appliance is installed and plugged into a 120 Volt grounded outlet. • This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No. 70-latest edition in the United States, or CSA C22.1, Part 1 in Canada, and local code requirements. Tools You Will Need Phillips® Screwdriver Pencil Ruler or Tape Measure and Straight-edge Hand Saw or Saber Saw Spirit Level Warm & Serve Drawer Installation 1.Locate the 2 anti-tip brackets supplied as shown on fig. 1. c/c 25 5/16" (64,3 cm) Use screws supplied to attach drawer to front of cabinet. Figure 2 Electrical connection IMPORTANT Please read carefully. For personal safety, this appliance must be properly grounded. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from the appliance. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3-prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. c/c 12 21/32" (32,2 cm) 24" (61 cm) Max. 23 5/8" (60 cm) Min. Figure 1 2.Slide drawer into cutout opening until front frame of drawer is flush against cabinet. Be careful not to pinch electrical cord. 3.Remove the drawer as instructed in the Use & Care Guide and secure drawer housing to cabinet using the 3 nickel-plated screws supplied (see Figure 2). Do not overtighten screws. 4.The 60" (152,4 cm) appliance power cord can now be connected into the 120 Volt outlet. 5.Proceed with mounting built-in oven above the drawer (if applicable). Follow installation instructions provided with built-in oven. Make sure to use anti-tip brackets supplied with the built-in oven. Disconnect electrical supply cord from wall receptacle before servicing cooktop. Preferred Method Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug. 2