Electrolux EWED65HIW Use and Care Guide - Page 26

26 Operating User Interface Features Setting Preferences, con't INSTALL CYCLE Run the INSTALL CYCLE before operating the dryer the first time. Remove all items from the dryer drum and press start. For more information on performing the dryer INSTALL CYCLE, refer to the Installation Instructions accompanying this dryer. If the dryer has been installed according to Installation Instructions, INSTALL PASS! will be displayed and the dryer is ready to use. If the dryer was not installed properly, SERVICE CORD, NO GAS or CALL SERVICE 877 435 3287 will be displayed to indicate the installation error. The errors may result from the following conditions: • SERVICE CORD (electric dryer)-The power supply cord has been installed improperly or the house wiring to the receptacle is incorrect. • NO GAS (gas dryer)-There is no connection between the dryer and the gas line or the valve is closed. • CALL SERVICE-Error can only be corrected by calling a qualified technician (1-877-435-3287). Repeat the INSTALL CYCLE when corrections are completed. NOTE The INSTALL CYCLE is prompted automatically only once when the dryer is turned on the first time at the end of installation. After that, if you wish to run a subsequent INSTALL CYCLE when moving the dryer or modifying your installation, you may perform your own INSTALL CYCLE by selecting it in the set prefs feature and then following the screen prompts.