Electrolux FMV156DS Installation Instructions - Page 4
Preparation Of The Oven, Ventilation System
View all Electrolux FMV156DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installation Instructions 7 PREPARATION OF THE OVEN 1. Turn oven on the side. See Figure 5. 2. Follow steps (A)-(D) to remove mounting plate from the back of the oven as shown in Figure 5. (A) Release mounting plate by pulling out the lever that is on the bottom of the oven. See Figure 6. (B) When lever is out, pull that side of the mounting plate away from the oven. See Figure 5. (C) Repeat step (A) on other side. (D) Repeat step (B) on other side. 8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION) This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Recirculating - non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has been installed in the oven. Horizontal Exhaust - outside ventilation. Follow installation procedure (B). Vertical Exhaust - outside ventilation. Follow installation procedure (C). (A) RECIRCULATING: Non-Vented, Ductless Operation 1. The unit is shipped assembled for recirculating. 2. The Exhaust Damper Assembly 9 is not required for recir- culating exhaust. (B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION 1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket, as shown in Figure 7. 2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan wiring. 3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 9 (A). Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B). 4. Put the wire back into the cavity. See Figure 10. (A) (B) (C) Figure 5 (A) Use screwdriver to assist in releasing mounting plate. Bottom of Microwave Figure 6 (D) Mounting Plate Figure 7 (A) Rotate 180˚ (B) Figure 8 Save fan cover bracket for future instructions. Figure 9 4 Figure 10