Electrolux RH30WC55GS Complete Owner's Guide (English) - Page 12

12 Installing the hood Making the electrical connections • If not already done, install 1/2" conduit connector in j-box. Electrical Shock Hazard Warning: Turn off power at the service panel before wiring this unit. 120 VAC, 15 or 20 Amp circuit required. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE CUT OR REMOVED. Failure to do so can result in death or electrical shock. • Remove junction box cover and knockout on the top left side. Knockout Junction box cover House wiring U.L. listed wire nut Metal electrical conduit • Run black (live), white (neutral), and green (earth) wires (#14 AWG) according to the National Electrical Code or CSA Standards and local codes and ordinances in 1/2" conduit from power supply to j-box. • Connect black, white, and green wires from power supply to black, white, and green/yellow wires in j-box respectively. • These connections should be done while always making reference to the electrical diagram found inside the hood. • Close j-box cover and reapply screws.