Electrolux SC899F Owners Guide - Page 6

GENERAL INFORMATION The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to prevent bag tears, hose clogs, and fan blade breakage with subsequent motor damage. Service Information The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone our toll free number for the nearest Eureka/Sanitaire Authorized Warranty Station. Refer to The Sanitaire Commercial Warranty for complete service information. You should know the model, type and serial numbers when you call: USA: 1-800-282-2886 Mexico: 5670-6169 Canada: 1-800-282-2886 DO NOT OIL the motor or the brush roll at any time. The bearings are permanently lubricated and sealed. Rating Plate The model, type, and serial numbers are indicated on the rating plate located on the underneath side of the cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service. MODEL VOLTS TYPE SERIAL NO. AMPS. HERTZ SERVICE INFORMATION: 1-800-282-2886 Model & Type Serial No HOW TO ASSEMBLE Assembly Packet The assembly packet is with the owner's guide. The packet contains two 2-part bolts and two cord hooks. An extra drive belt is also included with some models. Step 1 Assemble the Handle Slip the upper handle and the lower handle together so the handle bolt holes align and the slots in the handle are positioned as shown in Detail A. Insert a 2-part bolt (A) in the center of the handle and tighten. Hold the assembled handle so it curves away from the cleaner. Then push the handle into the handle socket (D) at the rear of the cleaner. Align the holes, insert the other 2-part bolt (A), and tighten. 6 B A C Detail A A D