Epson 5040UBe Warranty Statement - Page 3

WirelessHD Transmitter WirelessHD Transmitter model: WIT4-G0 This document provides safety instructions and describes the specifications. Read this document carefully before use to ensure your safety and product performance. U.S. FCC Notices FCC ID: BKMAE-WIT4-G0 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ■ Reorient or relocate the receiving antenna. ■ Increase the separation between the equipment and receiver. ■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ■ Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. To comply with RF exposure compliance requirements, a separation distance of at least 7.9 inches (20 cm) must be maintained between the antenna of this device and all persons. This antenna of this device must not be co-located or used in conjunction with any other antenna or transmitter. The cable for peripheral with a ferrite core must be used for RF interference suppression. Canada Industry Canada (IC) Notices IC: 1052D-WIT4-G0 This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. CAN ICES-3(B)/NMB-3(B) This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. 3