Epson 570e Transition Guide - Page 9

Changing Settings Through the Default Setting Mode The LQ-570e includes a Default Setting mode which lets you set the functions controlled by DIP switch settings on the LQ-570+, plus a number of additional features. The table below summarizes the differences. (Default settings are in bold.) To enter the Default Setting mode, make sure the printer is off and paper is loaded. Then hold down the Font button and press the power switch to turn on the printer. Instructions are printed which you can follow to change any settings. When you are finished, turn off the printer to exit the Default Setting mode. Note: You can also change the default settings using the EPSON Remote! utility. See Chapter 5 in your LQ-570e User's Guide. Setting Page length for continuous paper (tractor) Skip over perforation Auto tear-off Auto line feed Print direction Software (printer mode) 0 slash High speed draft I/F mode Auto I/F wait time Parallel I/F bidirectional mode Packet mode (IEEE 1284.4 protocol) LQ-570+ DIP switches 2-1 and 2-2 select 8.5, 11, 11.7, and 12 inches DIP switch 1-8 (On, Off) DIP switch 2-3 (On, Off) DIP switch 2-4 (On, Off) DIP switch 1-5 (Bi-D, Uni-D) DIP switch 1-6 (ESC/P2, IBM emulation) not available not available not available not available not available not available LQ-570e (Default Setting mode) Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12, 14, 17 On, Off On, Off On, Off Auto, Bi-D, Uni-D ESC/P 2, IBM® 2390 Plus On: 0 , Off: 0 On, Off Auto, Parallel, Optional 10 seconds, 30 seconds On, Off Auto, Off 9