Epson 585W Installation Guide - Ultra-Short Throw Wall Mount (ELPMB43) - Page 63
Remove the cable cover, Attach the Control Pad
View all Epson 585W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
English A Remove the cable cover B Attach the Control Pad Attach the Control Pad with commercially available M4 × 20 mm screws (×4). Warning ❏ Make sure the screws are not angled. ❏ Make sure the Control Pad is firmly attached. ❏ Do not attach the Control Pad with double-side tape or magnets. ❏ Check that the Control Pad is operating correctly before attaching it with the screws. ❏ When installing the Control Pad on a table, attach the supplied rubber feet (x4) to the base of the Control Pad to prevent it from slipping. 63
63
English
A
Remove the cable cover
B
Attach the Control Pad
Attach the Control Pad with commercially available M4 × 20 mm screws (×4).
❏
Check that the Control Pad is operating correctly before attaching it with the
screws.
❏
When installing the Control Pad on a table, attach the supplied rubber feet (x4) to
the base of the Control Pad to prevent it from slipping.
❏
Make sure the screws are not angled.
❏
Make sure the Control Pad is firmly attached.
❏
Do not attach the Control Pad with double-side tape or magnets.
Warning