Epson ActionPrinter 2250 Product Information Guide - Page 7
Switching to single sheets
View all Epson ActionPrinter 2250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Tips for using continuous paper . You can adjust the top-of-form position temporarily. Open the printer cover and turn the gear marked by + and - signs to adjust the position, This adjustment is lost when you turn off the printer or feed the paper backward to the paper-park position. 3. Replace the paper guide. paper-park position ActionPrinter 2250 l If you want to change the top-of-form position permanently, adjust it with the default-setting mode. l Each time you turn on the printer with paper loaded, it reverses the continuous paper to the paper-park position and then advances it to the next top-of-form. Always remove your printed sheets before you turn off the printer to keep the top-of-form position accurate. Note: When you set the back-feed setting to Disable in the default-setting mode, the printer does not feed the paper backward even if you press the LF/FF and FONT buttons or you ) turn on the printer with paper loaded. Removing the push tractor 1. Tear off any printed pages. Press the LF/FF and FONT buttons at the same time to feed the remaining paper backward to the paper-park position. Remove the paper from the push tractor. 0! CAUTION: Always tear off the printed document and excess paper before feeding paper backward. Never feed more than one page backward through the printer. 2. Turn off the printer and lower the paper-release lever to the single-sheet position. Then pull the push tractor straight down and out of the printer. Using the tear-off feature When you use continuous paper, the tear-off feature makes it easier to tear off the last printed sheet and save the paper normally lost between documents. Note: l You can tell the printer to feed the perforation of your paper to I either the edge of the printer cover or approximately 80 mm (three inches) beyond, by setting the tear-off option, l When you set the back-feed setting to Disable in the defaultsetting mode, the tear-off feature does not work. Here's how the tear-off feature works: 1. When the printer finishes printing the last page and the print head moves to the top-of-form position on the next page, the printer automatically advances the paper to the tear-off position. 2. The READY mode. light ( m-_ 9 ) blinks to indicate the printer is in tear-off 3. You can then easily tear off the page along the perforation. 4. When the printer receives data, it feeds the paper backward to the top-of-form position and the printer begins printing. Switching between continuous paper and single sheets When you use the push tractor, you can easily switch to single-sheet printing without removing the continuous paper supply. Switching to single sheets Here's how to switch from continuous paper to single sheets: 1. If you have a printed document still in the printer, tear off the printed pages and then press the LF/FF and FONT buttons at the same time to reverse the remaining paper back to the paper-park position. Always tear off printed pages before feeding paper backward; feeding too many sheets backward can Never feed labels backward. They can easily peel off of 9-Pin Printers 7/14/92 AP-2250-7