Epson BrightLink 696Ui Users Guide - Page 127

3. Aim the remote control at that projector. 4. Hold down the ID button on the remote control while you press the numeric button that matches the projector's ID. Then release the buttons. 5. Press the ID button on the remote control to check if the ID-setting process worked. You see a message displayed by the projector. • If the remote control is listed as On, the remote control ID is set to operate only the listed projector. • If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps above to set the ID to match the projector you want to control. Note: • You must set the remote control ID to match the projector ID each time you turn on the projector you have set it to control. • When you select 0 on the remote control, you can operate all projectors regardless of the Projector ID setting. • If you turn off the Projector ID setting, the remote control will operate the projector regardless of the ID selected on the remote. Parent topic: Using Multiple Projectors Related references Projector Setup Settings - Extended Menu Adjusting Color Uniformity If the color tone is uneven on each screen, adjust the color tone balance in the Extended menu of each projector. (The color tone may not be uniform even after performing color uniformity.) Note: If you cannot adjust color uniformity, make sure the Color Mode setting is not set to Dynamic. 127