Epson C11C486001 Start Here Card - Page 1
Epson C11C486001 - Stylus C82 Color Inkjet Printer Manual
UPC - 010343844353
View all Epson C11C486001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
EPSON Stylus C82 EPSON Stylus® C82 Start Here 2 Power On 1 Plug the printer's power cord into a grounded electrical outlet. 2 Press the printer's power button until the green power light comes on. Power button CAUTION: Use only the printer's power button to turn the printer on or off. 3 Load Ink 1 Lower the printer's output tray and open the cover. 1 Unpack 1 Remove everything from the box. CPD-14293R1 4025621-01 Paper support Printer Ink cartridges CD-ROM Manual 2 Remove all the blue tape and packing material inside and around the printer. The tape may be in slightly different places on your printer, so check carefully. 2 Shake the package of ink cartridges four or five times. Then remove the cartridges from the package. (Don't shake them after removing the packaging.) Don't touch the green circuit boards or remove any labels 3 Lower each ink cartridge into its holder with the green circuit board facing the back. Then gently push each ink cartridge down until it is firmly seated. The color of the cartridge label should match the marker on the holder. 4 Press the ink button and close the printer cover. 3 Slide the paper support into the grooves on either side of the sheet feeder. The paper support should fit securely. Ink button The green power light flashes as your printer charges ink for about 90 seconds. CAUTION: Don't turn off the printer while the green power light is flashing, unless the printer hasn't moved or made any noise for more than 5 minutes. 4 Connect the Printer Printer cables are not included with your printer. You need only one of the following cables: • USB cable (PC or Macintosh®) or • Parallel cable (PC only). NOTE: If you have Windows® 95 or NT 4.x, you must use a parallel cable. USB Cable Users (PC or Mac) 1 Shut down your computer. In Windows, click Start and select your Shut Down or Turn Off option. Leave your computer turned off until section 6. 2 Plug the square end of the cable into the USB port on the side of the printer. (It's right above the parallel port.) 3 Plug the flat end of the cable into your computer's USB port until it stops. (You can use any open USB port.) Flat end Square end Parallel Cable Users (PC only) 1 Shut down your computer. Click Start and select your Shut Down or Turn Off option. Leave your computer turned off until section 6. 2 Plug the end of the cable with the slotted connector into the parallel port on the side of the printer, then secure it with the wire clips. 3 Plug the end of the cable with the screws on the side into your computer's parallel port and secure it. End with screws Slotted end Turn over