Epson ELPMBATA Installation Guide - Page 6
Securing Receiver Tray to Pipe
UPC - 010343868595
View all Epson ELPMBATA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Securing Receiver Tray to Pipe Twist off the cap from the Pipe Thread Adhesive tube (B). Cut off the tip. Apply it to the inside of the coupler (C) at the top, for about 1/4" or approximately three threads. Screw the coupler (C) clockwise (as viewed from below), with the Receiver Tray (E) already assembled, onto the pre-installed 1-1/2" standard pipe threads (A). This connection should be as tight and stable as possible. WARNING: It is the installers responsibility to be sure that the structure to which this mount will be attached, can support four times the combined weight of the equipment, mount and supporting hardware. (not provided) INSTALLATION MANUAL 6
INSTALLATION MANUAL
6
Securing Receiver Tray to Pipe
Twist off the cap from the Pipe Thread Adhesive tube (B). Cut off the tip. Apply it to the inside of the
coupler (C) at the top, for about 1/4” or approximately three threads. Screw the coupler (C) clockwise
(as viewed from below), with the Receiver Tray (E) already assembled, onto the pre-installed 1-1/2”
standard pipe threads (A). This connection should be as tight and stable as possible.
WARNING: It is the installers responsibility to be sure that the structure to which this mount will be attached, can
support four times the combined weight of the equipment, mount and supporting hardware.
(not provided)