Epson ELPMBC01 Installation Guide - Page 5

Adjustment of Extension Column WARNING • Extension column (A) must be fully threaded (six or seven full turns) onto threaded fitting in ceiling plate and then locked with M5 x 10 mm screw. Skip to step 3 if adjustment is not required. 2 Remove M8 x 10 mm phillips screw from set hole in extension column (A) as shown in fig. 2.1. Slightly loosen M8 x 10 mm phillips screw in hook slot until inner column is loose. Rotate inner column left and slide down in to desired hook slot as shown in fig. 2.2 and 2.3. Securely tighten M8 x 10 mm phillips screw in hook slot. Fasten M8 x 10 mm phillips screw into set hole and inner column and retighten M8 x 10 mm phillips screw in hook slot as shown in fig. 2.1. M8 x 10 MM PHILLIPS SCREW WARNING • Do not loosen M8 x 10 mm screw to point of disengagement. Hold inner column securely while adjusting M8 x 10 mm screw. Tighten fasteners securely. A fig. 2.1 SET HOLE INNER COLUMN M8 x 10 MM PHILLIPS SCREW HOOK SLOT M8 x 10 MM PHILLIPS SCREW INNER COLUMN fig. 2.2 fig. 2.3 Visit the Peerless Web Site at www.peerlessmounts.com 5 of 6 ISSUED: 03-06-08 SHEET #: 154-9009-2 07-10-08 For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.