Epson EMP 62 User's Guide - Page 93
Solving Password Problems, Solving Problems with the Remote Control
View all Epson EMP 62 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Solving Password Problems You have forgotten the password. ■ Write down the request code that appears in the Password Protect Release screen and contact Epson. See "Where To Get Help" on page 95. ■ If you turned on the password protect feature before setting the password and no password was set before, try using the default password: 0000. The remote control is not available. You must have the remote control to enter the password. If necessary, you can purchase a replacement remote control from Epson. See page 96 for details about ordering. Solving Problems with the Remote Control The projector doesn't respond to remote control commands. ■ Make sure you are within 20 feet of the projector, and within range of the projector's front or back sensor (approximately 30° to the left or right and 15° above or below). ■ The remote control batteries may not be installed correctly or may be low on power. Replace the batteries as described on page 50. ■ Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector's infrared receivers. ■ Turn off any nearby equipment that emits infrared energy, such as a radiant room heater. Solving Problems 93