Epson ET-2550 User Manual - Page 2

5 Carefully seal the bottle using the reverse side of the bottle tip for proper disposal. 12 When the message to see the setup manual is displayed on the LCD screen, press and hold the OK button for 3 seconds. 6 Replace the ink tank cap securely. 3 seconds 13 Press the button to start charging the ink. Ink charging takes approximately 20 minutes. Ink charging is complete when stops flashing. 7 Repeat the previous steps for the remaining bottles. 8 Close the ink tank unit cover. 20 minutes Note: The ink bottles included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product or load paper while the product is charging or you'll waste ink. 9 Connect the power cord to the back of the product and to an electrical outlet. 3 Load paper 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. Caution: Do not connect to your computer yet. 10 Raise the control panel and turn on the product. 2 Slide the edge guide to the left. Note: If an error message appears, turn off the product and check that no protective material has been left inside the product. Caution: Do not lower the control panel without first squeezing the release bar underneath or you may damage the product. 11 To select English as your language, press the OK button. If you want to change the language, press or to select it, then press the OK button. Note: You can change the language later using the product's control panel. For more information, see the online User's Guide. 3 Load paper, glossy or printable side up and short edge first, against the right side of the rear paper feed slot.