Epson H6000II User Manual - Page 11

English Use the following or an equivalent commercially available cleaning sheet: PRESAT brand (KIC) "CHECK READER CLEANING CARD" Note: Be sure not to use an adhesive cleaning sheet. Follow the steps below: 1. Load roll paper in the printer, turn off the power, then open the roll paper cover and turn the power back on while holding down the RELEASE button. 2. Press the RELEASE button 7 times, then close the roll paper cover. The printer prints the following message on receipt paper, and the SLIP light flashes. 3. Insert the cleaning sheet like a standard check. CAUTION: Be sure that the sheet is inserted with the correct side up and that it is inserted in the correct direction. Use a cleaning sheet only one time; then discard it. 4. When the sheet is ejected, press the RELEASE button, and remove the sheet from the printer. Notes on using the MICR reader Do not install the printer near any magnetic fields. Be especially careful where you install your display device, and be sure to check the recognition rate of the MICR reader with the display device in place. Make sure that the printer is not subjected to any impact or vibration when it is performing a MICR reading. Endorsement Printing If your printer has the optional endorsement printing mechanism, install the endorsement ribbon following the steps below: Use the EPSON ERC-41. The use of any ribbon cassettes other than those approved by EPSON may damage the printer and will void the warranty. TM-H6000II with Image Scanner User's Manual 11