Epson Perfection V100 Photo Product Information Guide - Page 4

Epson Perfection V100 Photo 3. Lay the cover down flat next to the scanner. Placing Film in the Holder 1. Open the cover of the 35 mm film strip holder. Note: When scanning without the scanner cover, gently press down on your document to flatten it. 4. When you are finished scanning, replace the scanner cover. Placing Film or Slides Removing the Document Mat To scan film strips or slides, you need to remove the document mat from the scanner cover. This uncovers the transparency unit window so your scanner can use it to scan your film or slides. 1. Open the scanner cover and gently slide up the document mat to remove it. 2. Slide your film strip all the way into the film holder with the shiny base side facing down. Your images and any wording on the film strip should appear backwards on the side that faces up. 2. Use a non-abrasive microfiber cloth to wipe the document table before placing your film or slides. To place film for scanning, see the next section. To place slides for scanning, see page 5. Note: Hold the edge of the film gently or use gloves to touch the film; otherwise you may damage the film. Make sure the white stickers on the back of the film holder and the areas around them are not scratched, dusty, or covered in any way. If the areas are obscured, the scanner may have trouble recognizing your film in Full Auto Mode. Do not cover the small holes in the film holder. 3. Close the cover and press it down until you hear a click. 4 - Epson Perfection V100 Photo 7/06