Epson PowerLite 715c Product Information Guide - Page 10

EPSON PowerLite 505c/715c Projector Replacing the Lamp The projection lamp typically lasts for about 1000 hours of use. It is time to replace the lamp when you see the following: ❏ The projected image gets darker or starts to deteriorate. ❏ The lamp warning light on top of the projector is red, flashing red, or orange. ❏ The message LAMP REPLACE appears on the screen when the lamp comes on (after about 900 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible. Warning: Let the lamp cool before replacing it. Also, do not touch the glass portion of the lamp assembly. Touching the glass portion of the lamp will result in premature lamp failure. Contact your dealer or call EPSON at (800) 873-7766 in the United States and Canada for a replacement lamp. Request part number ELPLP14. Follow these steps to replace the lamp: 1. Turn off the projector, then unplug the power cord. 2. Allow the projector to cool down for at least half an hour (if it has been on). Warning: If the lamp breaks, handle the shards carefully to avoid injury. 3. Turn the projector upside-down to access the lamp compartment. 4. Use a screwdriver to loosen the retaining screw on the lamp cover. (You can't remove the screw from the cover.) When the screw is loose, lift off the lamp cover. ) 6. Lift up the wire handle, as shown, and pull the lamp straight out. handle 7. Gently insert the new lamp. 8. Once the lamp is fully inserted, tighten its screws. 9. Replace the lamp cover and tighten its screw securely. (The projector won't come on if the lamp cover is loose.) 5. Use a screwdriver to loosen the two screws holding the lamp in place. (You can't remove these screws.) 10 - EPSON PowerLite 505c/715c Projector 1/01