Epson PowerLite 810p Product Information Guide - Page 10

EPSON PowerLite 600p/800p/810p Projectors 4. If you need to replace the filter, make sure the projector is on its side as shown (not turned upside down) to prevent dust from falling inside. Then press the arrow tab to remove the filter. 3. Use a screwdriver to slide the latch and pop open the lamp cover. Then lift it up and remove it. arrow tab 4. Use a screwdriver to loosen the two silver screws holding the lamp in place. (You can't remove these screws.) 5. To install the new filter, first insert the tabs, then press on the latch until it clicks in place. Replacing the Lamp The projection lamp typically lasts for about 1500 hours of use. It is time to replace the lamp when: ❏ The projection image gets darker or starts to deteriorate. ❏ The lamp warning light is red or flashing red. ❏ The message LAMP REPLACE appears on the screen when the projector lamp comes on (after about 1400 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible. Note: You can check to see how many hours the lamp has been used through the About menu. Contact your dealer or call EPSON at (800) 873-7766 in the United States and Canada for a replacement lamp. Request part number V13H010L15. Warning: Be extremely careful when removing the lamp module. In the unlikely event that the bulb has ruptured, small glass fragments may be present and should be removed with caution. If your projector is mounted on the ceiling, you should unmount it before accessing the lamp compartment. This will make it easier for you to replace the lamp and minimize the chance of any small glass fragments dropping from the projector. Follow these steps to replace the lamp: 1. Turn off the projector and unplug the power cord. 2. Allow the projector to cool down for at least half an hour (if it has been on). 5. Grasp the lamp as shown, and pull the lamp straight out. Caution: Do not touch the glass portion of the lamp assembly. 6. Fully insert the new lamp. 7. Once the lamp is fully inserted, tighten its screws. 8. To replace the lamp cover, insert the tabs and then snap the cover into place. (The projector won't come on if the lamp cover is loose.) 10 - EPSON PowerLite 600p/800p/810p Projectors 8/01