Epson PowerLite 83c Product Information Guide - Page 13
Resetting the Lamp Timer, Caution - power cable
View all Epson PowerLite 83c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5. Use the screwdriver to loosen the two screws holding the lamp in place. (You can't remove the screws.) Don't remove these screws PowerLite 822p/83c Projector 8. Once the lamp is fully inserted, tighten its screws. 6. Hold the lamp as shown and pull it straight out. 9. Lower the lamp cover into place. (The opening should be almost covered, and the top of the cover should be flush with the top of the projector.) Then slide the cover closed and tighten the screw. Note: The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put in the trash. 7. Gently insert the new lamp along the guide rail. If it doesn't fit easily, make sure it's facing the correct way. Push the lamp down firmly where the label PUSH appears. Note: Be sure to seat the lamp fully and secure the lamp cover. If the lamp is not properly installed or the cover is loose, the lamp will not turn on. 10. Reset the lamp timer as described in the next section. Resetting the Lamp Timer You must reset the lamp timer after replacing the lamp to clear the Replace the Lamp warning message. Follow the steps below. Note: Do not reset the lamp timer if you have not replaced the lamp. If you do, the Lamp Hours will not accurately reflect the number of hours that the lamp has been used. 1. Connect the power cable and turn on the projector. Caution: Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure. 3/08 PowerLite 822p/83c Projector - 13