Epson PowerLite Pro Cinema 800 Product Information Guide - Page 5

Compatible Video Formats The projector supports NTSC, PAL, and SECAM, as well as the digital video formats listed below. Digital video formats Format Signal name SDTV 480i 480p 576i 576p HDTV 720p 1080i Resolution 960 × 720 960 × 720 960 × 720 960 × 720 1280 × 720 1280 × 720 Aspect ratio 4:3 4:3 4:3 4:3 16:9 16:9 Turning the Projector On and Off 1. Connect the power cord to the projector and a grounded electrical outlet. 2. Remove the lens cap. 3. Turn on any connected equipment you plan to use. 4. Turn on the power switch on the back of the projector. Epson PowerLite Pro Cinema 800 Turning Off the Projector 1. Turn off any equipment connected to the projector. 2. Press the Off button on the remote control (or press the PPower button on the projector twice). 3. Let the projector cool for about 30 seconds. 4. Once the light stops flashing and stays on, turn off the power switch on the back. Caution: Turn the projector off when not in use. Continuous 24-hour-a-day use may reduce its overall life. Never unplug the projector without pressing the Off button and letting it cool, or you could damage it and reduce lamp life. Locking the Projector You can lock the projector to prevent the image from being accidentally changed once it's adjusted, and to keep children from using the projector without adult supervision. 1. Press the Menu button on the projector or remote control. 2. Use the menu navigation buttons to open the Setting menu, then open the Operation menu. 3. Choose from these options: ❏ Child Lock to disable the P Power button on the projector's control panel unless it is pressed for about 3 seconds. ❏ Operation Lock to disable all the buttons on the projector's control panel. To operate the projector, you have to use the remote control. 4. Press Menu to exit the menu system. Turn off the projector to activate the Child Lock. Power switch 5. Press the On button on the remote control, or press the PPower button on the projector. The projector takes about 10 seconds to warm up. If you don't see an image, you may need to select the image source (see the next column).[] Basic Image Adjustments Once the projector is turned on, use these functions to adjust the image. Selecting the Image Source If you don't see the image you want, press the Source button on the projector or the button on the remote control that corresponds to the port to which your video equipment is connected. 11/05 Epson PowerLite Pro Cinema 800 - 5