Epson Pro Cinema LS10500 Quick Setup and Warranty - Page 2
Adjust the image, Viewing 3D images, Troubleshooting
View all Epson Pro Cinema LS10500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Adjust the image 1 Press the Pattern button on the remote control to display a test pattern. 2 To raise the image or correct a tilted image, adjust the front feet as shown below. Viewing 3D images To view 3D content, you must first connect a 3D-compatible video device to one of the HDMI ports on your projector. 1 Turn on and begin playback on the 3D-compatible video device. Note: Make sure you set the video device to play content in 3D mode. 2 Press the 2D/3D button on the remote control, if necessary. 3 Slide the power switch on your 3D glasses to the On position. 3 Press the Lens button on the remote control and use the and buttons to focus the image. 4 Press the Lens button on the remote control again and use the and buttons to reduce or enlarge the image. Note: If the glasses don't automatically display 3D content, you may need to pair them with the projector. Move the glasses within 10 feet (3 m) of the projector, then press and hold the Pairing button on the 3D glasses for at least 3 seconds. The status light on the glasses will alternately flash green and red, then remain green for 10 seconds if pairing is successful. 5 Press the Lens button on the remote control again and use the , , , and buttons to reposition the image. 6 If your image looks like or projector to correct this. , you can use the button on the Note: Using the keystone adjustment can affect the size and effective resolution of your image. If possible, change the position of your projector to eliminate the keystone effect and use the lens shift option to position the image as necessary. 7 Press the Esc button on the remote control to exit. You can also automatically convert 2D HDMI content to 3D. To enable the 2D-to-3D Conversion option, press the Menu button on the projector or remote control. Select Signal and press Enter, then select 3D Setup and press Enter. Select 2D-to-3D Conversion and press Enter. Select the Weak, Medium, or Strong setting, then press Enter. For more information on adjusting 3D images, see the online User's Guide. Troubleshooting If you see a blank screen or the No signal message after turning on your video device or computer, check the following: •• Make sure the power light on the projector is blue and not flashing. •• Press the Source button on the projector or one of the Source buttons on the remote control to switch to the correct image source, if necessary. •• On some Windows® laptops, you may need to hold down the Fn key and press F7 or the function key that lets you display on an external monitor. It may be labeled CRT/LCD or have an icon such as . •• On Windows 7 or later, hold down the Windows key and press P at the same time, then click Duplicate. •• On a Mac, open System Preferences and select Displays. Click the Arrangement tab and select the Mirror Displays checkbox. If 3D images aren't displaying properly, check the following: •• Press the 2D/3D button to switch to 3D viewing mode, if necessary. •• Make sure that you are within the 3D viewing range. For more information, see "Choose a location" on the front of this sheet or the online User's Guide. •• Check that your 3D glasses are charged and have not entered standby mode. Slide the power switch on the 3D glasses to the Off position, then back to the On position.