Epson RX500 Start Here Card - Page 4

6 Press down on each cartridge until it clicks into place. Then close the ink cartridge cover. Caution: Don't force the cartridge cover closed. If it doesn't close easily, open it and make sure all the ink cartridges are firmly seated. 7 Lower the scanner unit. The RX500 begins charging the ink delivery system. Charging takes about 2 minutes. Initial charge appears on the RX500 screen. Note: Don't turn the RX500 off while you see the Initial Charge message or you'll waste ink. 7 Load Paper 1 Insert the paper support into the two slots on the back of the RX500. 2 Connect the short cable leading from the scanner lid to the round connector on the back of the RX500. Position the connector as shown here before pushing it in. Don't force it. 3 Open the output tray. 4 Flip the feeder guard forward. 5 Place a stack of paper in the top of the RX500, between the edge guides and beneath their tabs. Then slide the left edge guide against the paper, but not too tightly. 6 Flip the feeder guard back over the stack of paper. Note: If you forget to flip the feeder guard back, your paper may jam.