Epson RX620 Product Information Guide - Page 14
Placing 35 mm Slides on the Film Holder, Cleaning the Print Head - stylus photo ink
UPC - 010343851887
View all Epson RX620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Epson Stylus Photo RX620 Placing 35 mm Slides on the Film Holder 1. Position the film holder so that the 35 mm slide section faces the center of the scanner glass. The positioning posts fit in two small holes near the scanner lid, as shown. Flourescent lamp Film strip is in middle of glass 2. Places slides in the film holder as shown, with the duller (emulsion) side facing up. Make sure the top of images with portrait orientation face the front of the RX620 Note: If your slide image is in landscape orientation (wider than it is long), place it in the same direction as slide images in portrait orientation (longer than they are wide). This copies the maximum image area, but your preview will be rotated. 3. Close the scanner lid. Now you are ready copy, print, or scan. See the User's Guide for instructions. Cleaning the Print Head If your printouts are unexpectedly light, or dots or lines are missing, you may need to clean the print head. This unclogs the nozzles so they can deliver ink properly. Print head cleaning uses ink, so clean it only if quality declines. Note: You can also clean the print head using the printer software. Click the ? or Help button on your printer settings window for instructions on running the print head cleaning utility. 1. Make sure the RX620 is turned on but not printing. 2. Press the Setup button to enter setup mode. 3. Press the u and d buttons to select Head cleaning. 4. Press the OK button, then press OK to start cleaning the print head. Cleaning takes about 30 seconds, during which the message Head Cleaning appears on the LCD screen. Caution: Never turn off the RX620 while the message Head Cleaning appears on the LCD screen, unless the RX620 hasn't moved or made noise for more than 5 minutes. 5. When head cleaning is finished, you return to the Setup Menu. Use the u and d buttons to select Nozzle Check. 6. Make sure letter-size paper is loaded. Press the OK button, then press OK to print a nozzle check. Note: You can also print a nozzle check using the printer software. Click the ? or Help button on your printer settings window for instructions on printing a nozzle check. 7. Examine the nozzle check pattern you printed. Each staggered line should be solid, with no gaps, as shown. ❏ If your printout looks okay, you're done. Click Cancel to return to the main menu. ❏ If you see any gaps (as shown below) in the dot pattern, press OK. Then follow the instructions on the LCD screen to clean the print head again. 14 - Epson Stylus Photo RX620 11/04