Epson RX620 Start Here Card - Page 5

6 Install Software and Connect to Your Computer The software works with Windows ® 98SE, Me, 2000, and XP, and Macintosh® OS 9.2.x and 10.2.x to 10.3.x. Follow the steps below (for Windows), or the steps in the next column (for Macintosh). W i n d o w s 1 Make sure the RX620 is not connected to your computer, then turn on your computer. Note: If you see several New Hardware Wizard screens, click Cancel for each of these screens and disconnect your RX620. You can't install your software that way. 2 Insert your RX620 software CD-ROM in your CD-ROM or DVD drive. Note: If you're using Windows XP and you see a message asking what to do with your CD, click Cancel. 3 When you see this screen, then click Install. Note: If you don't see this screen, do the following: Windows XP: click Start > My Computer. Then double-click the Epson CD-ROM icon. Windows 98/Me/2000: double-click My Computer. Then double-click the Epson CD-ROM icon. 4 Read the license agreement, then click Agree. Several messages display on your screen. 5 When you see this screen, plug the flat end of the USB cable into any available USB port on your computer. 6 Click Next to continue the installation. Note: It will take several minutes to install the software. Click Next or Finish, as prompted. Don't cancel the installation. 7 When the installation is complete, print a test page, if desired. Then click Next to install optional software. 8 Follow the instructions on the screen to install the software. When done, click Exit. 9 When you see the Product Registration screen, register your RX620 as instructed, then remove the CD-ROM and restart your computer. Now you're ready to copy, scan, and print. See the Quick Guide or your on-screen Reference Guide for instructions. continue