Epson SP7900HDR User's Guide - Page 191

Solving Problems | 191 Problem Your print has horizontal banding. Your print has vertical banding. Improving Print Quality You can often improve print quality by doing the following: • Run a nozzle check and cleaning cycle. See page 162 for instructions. • Align the print head. See page 166 for instructions. • When you send a print job, make sure your print options are set correctly. For more information, see page 87 (Macintosh) or page 123 (Windows). If none of these suggestions help, try the solutions in the following table. Solution ◗ Check the ink indicators and light to see if you are low on ink. (If you replace ink cartridges with the printer turned off, the ink indicators will not be accurate.) Replace ink cartridges if necessary, as described on page 167. ◗ Run a nozzle check and cleaning cycle. See page 162 for instructions. ◗ Turn off the High Speed setting. ◗ Make sure the Media Type setting in the printer software is correct. ◗ If you're using cut sheet media, make sure the printable side is face up. ◗ Choose a higher resolution, such as SuperPhoto - 2880x1440dpi. ◗ If you're using a third-party RIP and non-Epson media, see if the RIP provides a method for adjusting the paper feed. Try adjusting your advanced media control settings (page 97) or paper configuration settings (page 113 for Mac OS X or page 141 for Windows). Check these settings: ◗ Make sure the Paper Thickness setting is correct for your paper. ◗ Use the Paper Feed Adjustment to tune out banding. Reduce the value for white lines, and increase it for overlapping dark lines. ◗ If you've created a custom paper configuration, be sure to return the setting to standard (STD) when you're done using it. See page 83. ◗ Turn off the High Speed setting. ◗ Align the print head; see page 166. 191