Epson Stylus COLOR 850Ne Product Information Guide - Page 6

EPSON Stylus COLOR 850Ne Setting Loading position Economy Parallel I/F transfer rate Options 8.5 mm, 3 mm, Others Off, On Fast, Normal Changing control panel settings Follow these steps to change the settings listed above: 1. Make sure the printer is turned off and has paper loaded. 2. Hold down the X color cleaning button and press the Ppower button. The printer prints a summary of instructions for changing settings and choosing a language for the instructions. 3. Press the X color cleaning button to print a list of current settings (indicated with arrows) and additional instructions. 4. After you make the changes you want, turn the printer off to save the settings. The settings remain in effect until you change them again. Character Tables All character tables except Italic are the same as the PC437 table for hex codes 00 through 7F. Additional characters are available for hex codes 80 through FF. You can select the following character tables through the control panel or software commands: • PC 437 (U.S./Standard Europe) • PC850 (Multilingual) • PC860 (Portuguese) • PC861 (Icelandic) • PC863 (Canadian-French) • PC865 (Nordic) • Abicomp • BRASCII • Roman 8 • ISO Latin 1 • Italic (no characters available for hex code 15) International character sets You can select a number of international character sets with the control panel or the ESC R command. Other sets can only be selected with the ESC R command. You can select additional characters with the ESC ( ^ command. Control Panel black cleaning button color cleaning button paper out light black ink out light color ink out light load/eject button power button power light Follow these guidelines when the control panel lights come on or flash: S S B A B A P P S B A When the paper out light flashes, paper is jammed in the printer. Turn off the printer and gently pull out all paper. Then press the E load/eject button. When the paper out light comes on, your paper ran out or is incorrectly loaded. Load paper in the feeder and then press the E load/eject button. When an ink out light flashes, your ink supply is low. Make sure you have a replacement cartridge. When an ink out light comes on, you need to replace the ink cartridge. When the power light flashes, the printer is receiving a print job or performing a maintenance operation. When all the lights flash, your printer may have an internal error. Testing the Printer You can run a self test to determine whether the problem comes from the printer itself or some other source. t If the results are satisfactory, the problem lies in your software settings, the network and configuration, or your computer. t If the self test does not print correctly, you have a problem with your printer. Follow these steps to run the test: 1. Make sure both the printer and computer are turned off. 2. Disconnect the network cable from the printer. 3. Make sure paper is loaded in the printer. Caution: Load paper that's at least 8.27 inches (210 mm) wide. This prevents ink from spraying inside the printer and smudging your printouts. 6 - EPSON Stylus COLOR 850Ne 10/98