Epson Stylus COLOR 850Ne Product Information Guide - Page 8

EPSON Stylus COLOR 850Ne Resetting the Ethernet Card When the Ethernet card's status lights show an error condition, you may be able to correct it by resetting the printer memory. Press the P power button. After the lights on the card go out, press the button again. Remove the yellow tape seal, but don't remove the white portion power button Installing Ink Cartridges for the First Time Always use the ink cartridges that came in the box the first time you set up the printer. Follow these steps to install the ink cartridges: 1. Make sure the printer is turned off (the P power button should be up). Then plug the printer's power cord into a grounded outlet. Caution: Always use the P power button to turn the printer on or off. Never use an external switch-such as a power strip switch-to turn off the printer. Don't use an outlet that can be turned off by a wall switch or timer, or one that uses the same circuit as a large appliance. This may disrupt the power, which can erase memory or even damage the printer's power supply. 2. Remove the ink cartridges from their foil packages. Then remove only the yellow part of the tape seal on the top of each one. Don't pull off the white portion or try to remove the clear seal underneath the cartridge. black cartridge color cartridge Caution: To ensure the print heads charge correctly, install the ink cartridges that came with the printer. You must remove the yellow tape from the top of the cartridge or you will permanently damage it. It's OK if a small corner of the yellow tape stays on the cartridge. Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in your eyes, flush them immediately with water. 3. Press the P power button to turn on the printer. The P power light flashes and the B black and A color ink out lights come on. The black ink cartridge holder moves into loading position. 4. Open the printer cover and lift up the black ink cartridge clamp. black ink cartridge holder 5. Place the black ink cartridge in the holder with the label pointing up and the arrow pointing to the back of the printer. Then close the clamp, making sure it clicks into place. 8 - EPSON Stylus COLOR 850Ne 10/98