Epson Stylus NX330 Start Here - Page 2
Load paper - all in one printer
View all Epson Stylus NX330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
5 Lower the scanner unit. 4 Slide the edge guide to the left. 6 Press OK to prime the ink delivery system. Priming takes about 4 minutes. Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. Caution: Don't turn off the printer while it is priming or you'll waste ink. 7 When you see this menu on your product's LCD screen, do not press the OK button yet. Continue with the instructions in the following sections to load paper into your product and install software. 5 Load paper against the right edge guide and behind the tab, with the printable side faceup. 8½ × 11 inch (216 × 279 mm) 5 Load paper 1 Flip the feeder guard forward. 4 × 6 inch (102 × 152 mm) Note: Don't load the paper sideways; always load it short edge first. 6 Slide the edge guide over, against the left edge of the paper. 2 Raise the paper support, if necessary. Then pull up the extension and tilt it back slightly. 7 Flip the feeder guard back. 3 Pull out the output tray, then raise the paper stopper.