Epson Stylus Photo R3000 Start Here - Page 2

Caution: Don't remove any other seals or the cartridges may leak. 4 Insert the cartridges in the holder for each color. 3 Load paper against the right edge and behind the tab. Then press the button on the edge guide and slide it to the edge of the paper. 5 Press the cartridges down until they click. 6 Close the cartridge cover, then close the printer cover. 7 The printer begins priming the ink delivery system. This takes about 10 minutes. Do not turn off the printer, load paper, or open any covers until the process is complete. Caution: Don't turn off the printer while it is priming or you'll waste ink. 4 Load paper Sheet feeder You can load plain paper, and most glossy and matte papers, in the sheet feeder. 1 Open the paper support and pull up the extensions. Note: Don't load the paper sideways. Always load it short edge first. Front manual feed tray You can print on these fine art media using the front manual feed tray: • Epson Velvet Fine Art Paper • Epson Watercolor Paper Radiant White • Epson UltraSmooth® Fine Art Paper • Epson Exhibition Fiber Paper • Epson Hot Press Bright • Epson Hot Press Natural • Epson Cold Press Bright • Epson Cold Press Natural • PremierArt™ Matte Scrapbook Photo Paper for Epson Note: For instructions on loading roll paper, a CD or DVD, or thick media, see the printed Basics guide. 1 Remove any paper from the sheet feeder. 2 Open the rear support. 3 Fully extend the rear support. 4 Open the front cover, then push the center of the manual feed tray to extend it. 2 Open the front cover, then extend the output tray. 5 Insert a single sheet of fine art media. Insert it short end first with the printable side face up.