Epson Stylus Photo RX600 Start Here Card - Page 6

8 Install Software and Connect to Your Computer The software works with Windows® 98SE, Me, 2000, and XP, and Macintosh® OS 9 and OS X 10.2 and later. Windows 1 Make sure the RX600 is not connected to your computer. Then turn on your computer. Note: If your RX600 is turned on and connected, you may see several New Hardware screens. Click Cancel on each of these screens and disconnect the RX600. You can't install your software that way. 2 Insert the Epson CD-ROM in your CD-ROM or DVD drive. Note: If you're using Windows XP and you see a message asking what to do with your CD, click Cancel. 3 When you see this screen, click Install: If this screen doesn't appear, do the following: Windows XP: Click Start > My Computer. Then double-click the EPSON CD-ROM icon. For Windows 98/Me/2000: Double-click My Computer. Then double-click the EPSON CD-ROM icon. 4 Read and agree to the license agreement to continue. You see this screen and the installer begins copying several software programs to your computer: 5 When you see this screen, connect the USB cable extending from the RX600 to any open USB port on your computer. Several messages appear on the screen. Wait for all the screens to disappear. Note: If the blue USB screen doesn't disappear, make sure the RX600 is turned on and securely connected to your computer. If you see a message about a Hi-speed device plugged into a non-Hi-speed hub, close the message screen. 6 When you see a message that you have successfully installed the RX600 drivers, click Next. continue