Epson Stylus Pro 9600 - UltraChrome Ink Product Information Guide - Page 13

EPSON Stylus Pro 7600 and 9600 Charging the Ink Once draining is complete, make sure you have the correct black ink cartridges available for the black ink mode you're switching to. Then follow these steps: 1. Insert all the ink cartridges into the printer. Be sure to install the correct black ink cartridges for the black ink mode you're switching to. 2. Lower the ink lever. The printer begins charging the ink delivery system. 3. Once the charging is complete, the printer stops making noise and displays READY on the control panel. Continue on to the next section to update your printer driver software. Updating the Macintosh Driver If you're printing from a Macintosh, you need to update the driver so that it knows which black ink mode you're using. (In Windows, the driver is updated automatically.) 1. Open the Chooser from the Apple menu. 2. Click the printer icon and port, as shown. Replacing the Cutter Blade If you notice that your paper isn't cut cleanly, the cutter blade may need to be replaced. If you use the blade to cut heavy stock or non-EPSON media, you may need to replace it more often. You can check the status of your cutter by printing the status check sheet (see page 9). 1. Make sure that the printer is on and the front cover is closed. 2. Press the SelecType button on the control panel. You see PRINTER SETUP. 3. Press d until you see MAINTENANCE, then press r. You see PWR CLEANING. 4. Press d until you see CUTTER REPL, then press r. You see EXEC. 5. Press Enter. The carriage moves to the cutter replacement position. 6. You see a message on the control panel telling you to open the front cover. Open the cover to access the carriage. Click here . . . then here 7. Push down on the side pin, then turn the latch to the right. Close when done 3. Close the Chooser. This completes the black ink replacement. 7/02 EPSON Stylus Pro 7600 and 9600 - 14