Epson SureColor F9370 Users Guide - Page 151
LCD screen message, Solution, Job Cancel, necessary, refill the ink and replace the chip unit.
View all Epson SureColor F9370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
LCD screen message Solution Chip unit error Chip unit not recognized. Replace chip unit. Chip unit error Cannot be recognized. Remove and reinstall the chip unit. If the error recurs, replace the chip unit with a new one. Make sure the chip unit is installed properly on the correct ink tank color. Condensation may have formed inside the ink tank. Make sure the ink is at room temperature for at least four hours. If you still have problems, contact Epson for support. Remove or replace chip unit. Chip unit error Chip unit not recognized. Did you check the names of the supported products on the ink pack before adding the ink into the printer? Chip unit error Replace with chip unit that supports this printer. Please check ink level. Check the remaining ink in the ink tank using the scale on the ink pack and, if Printing will pause if chip necessary, refill the ink and replace the chip unit. unit is not replaced. Make sure you have a replacement ink pack in the correct color handy. Warming Up... OK Force to start printing The after heater is still warming to the specified temperature. Press the OK button to start printing without waiting for the after heater to warm up. Clogged nozzles detected. Press the pause/cancel button and select Job Cancel to cancel printing. Perform a head cleaning based on the printout results. Cleaning recommended. 151