Epson SureColor S60600 User Manual - Page 120
LCD screen message, Solution, Job Cancel, Media Size Check, Auto Take-up Reel Unit stopped.
View all Epson SureColor S60600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
LCD screen message Solution Warming Up... Force to start printing One or more heaters is warming up to the specified temperature. To start printing without waiting for the heater to warm up, press the OK button. Command Error Check print settings on RIP. Press the pause/cancel button and select Job Cancel. Make sure the installed RIP software is compatible with the product. Clogged nozzles detected. Perform head cleaning if necessary. Cleaning recommended. F/W Install Error Firmware update failed. Restart the printer. Turn off the product, wait a few minutes, and turn it on again. Then reinstall the firmware again. If this message persists, contact Epson for support. Print head is nearing end of service life. The print head is nearing the end of its service life. Contact Epson for support. Auto Take-up Reel Unit stopped. Press the pause/cancel button and select Job Cancel to cancel printing. Then set the Auto switch on the auto take-up reel to the off position, set it back to the original position, and reattach the media to the auto take-up reel. Media Size Error Load correct size media. Raise the media loading lever and remove the currently loaded media. Be sure the media is at least 11.8 inches (300 mm) wide. If this message appears even when the media is the correct width, turn off the Media Size Check setting and try printing again. 120