Epson TM U295 Operation Guide - Page 58
ESC T, xL xH yL yH dxL dxH dyL dyH
View all Epson TM U295 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
ESC T n [Name] Select print direction in page mode [Format] ASCII ESC T n Hex 1B 54 n Decimal 27 84 n [Range] 0 ≤ n ≤ 3 48 ≤ n ≤ 51 [Description] Selects the print direction and starting position in page mode. n specifies the print direction and starting position as follows: n Print Direction Starting Position 0, 48 1, 49 2, 50 Left to right Bottom to top Right to left Upper left (A in the figure) Lower left (B in the figure) Lower right (C in the figure) A Printing area B C 3, 51 Top to bottom Upper right (D in the figure) Paper feed direction D [Notes] [Default] • When the printing direction is changed, the printing direction and print starting position for the data following are those specified by n. • Only setting of this command is effective in standard mode. • If n is out of the specified range, this command is ignored. n = 0 ESC W xL xH yL yH dxL dxH dyL dyH [Name] Set printing area in page mode [Format] ASC II ESC W xL xH yL yH dxL dxH dyL dyH Hex 1B 57 xL xH yL yH dxL dxH dyL dyH Decimal 27 87 xL xH yL yH dxL dxH dyL dyH [Range] 0 ≤ xL≤ 255, xH=0, 0 ≤ yL≤ 255, 0 ≤ yH≤ 1, 0 ≤ dxL≤ 255, dxH=0, 0 ≤ dyL≤ 255, 0 ≤ dyH≤ 1 (Except for dxL=dxH=0 or dyL=dyH=0) [Description] Sets the position and the size of the printing area. • When the horizontal print start position, vertical print start position, horizontal length, and vertical length are defined as x0, y0, dx (dot), dy (dot), respectively. Each setting for the printable area is calculated as follows: x0 = [(xL + xH ! 256)] y0 = [(yL + yH ! 256)] 5-18 Commands