Epson TM U295 Operation Guide - Page 63
ESC p, m t1 t2 - slip printer
View all Epson TM U295 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
[Description] Sets the time that the printer waits for slip paper to be inserted and the time from insertion of the sheet to the start of printing. • t1 specifies the wait time for a cut sheet to be inserted. There is no limitation for the wait time and the printer waits until slip paper is inserted. • t2 specifies the time from insertion of the sheet to the start of printing. • The printer starts operation [t2 × 0.1] seconds after detecting slip paper. [Note] When either t1 or t2 is out of the specified range, this command does not change the previously set wait time. [Default] t1 = 0, t2 = 10 ESC p m t1 t2 [Name] Generate pulse [Format] ASCII ESC p m t1 t2 Hex 1B 70 m t1 t2 Decimal 27 112 m t1 t2 [Range] m = 0, 1, 48, 49 0 ≤ t1 ≤ 255 0 ≤ t2 ≤ 255 [Description] Outputs the pulse specified by t1 and t2 to connector pin m as follows: m Connector pin 0, 48 Drawer kick-out connector pin 2 1, 49 Drawer kick-out connector pin 5 [Notes] • The pulse ON time is [t1 ! 2 ms] and the OFF time is [t2 ! 2 ms]. • If m is outside the specified range, the printer ignores this command and the following data is processed as normal data. ESC q [Name] Paper release [Format] ASCII ESC q Hex 1B 71 Decimal 27 113 [Description] Releases the paper [Notes] • This command is available only in standard mode. • When the panel button is disabled and the specified paper sensor detects a paper-end, the printer releases the paper, regardless of this command. Commands 5-23