Epson U295 User Manual - Page 6

English Control Panel RELEASE button Press this button to insert or remove paper. REVERSE button Feeds paper backward. FORWARD button Feeds paper forward. POWER LED ON when the printer is on. RELEASE LED ON when the printer is in release mode (to insert or remove paper). OFF when the printer is in clamp mode (to hold paper). FLASHES to indicate an error. PAPER OUT LED ON when paper is not inserted or is not inserted correctly. Removing the Transportation Damper The printer is protected during shipping by a transportation damper 1 that you must remove before you turn on the printer. Pull the damper out and remove the strip of tape from the top of the printer, as shown in illustration 1. Note: Prepare the printer to ship or store with these steps: turn on the printer, press the RELEASE button, press the FORWARD button, turn off the printer, and reinstall the transportation damper. Installing a Ribbon Use the Epson ERC-27 ribbon cassette. The use of any ribbon cassettes other than those approved by Epson may damage the printer and will void the warranty. 1. Turn the printer on using the power switch on the left side. 2. Press the RELEASE button (the RELEASE LED lights). This puts the printer in the paper release mode. 3. Turn the printer off. CAUTION: Perform the steps above to make sure the printer is in the paper release mode before you install or remove a ribbon cassette. 6 TM-U295/U295P User's Manual