Epson V350 Product Information Guide - Page 4

Epson Perfection V350 Photo Placing Large or Thick Documents When you need to scan a large or thick document, you can either raise the lid to its highest posistion, or open the scanner cover all the way as described below, so that it lies flat next to the scanner. 1. Open the scanner cover. 2. Pull the scanner cover straight up. 1. Open the scanner cover and gently slide up the document mat to remove it. 3. Lay the cover down flat next to the scanner. 2. Use a non-abrasive microfiber cloth to wipe the document table before placing your film or slides. To place film for scanning in the film holder, see the next section. To place film for scanning in the auto film loader, see page 5. To place slides for scanning, see page 7. Placing Film in the Holder 1. Slide your film strip all the way into the film holder with the shiny base side facing down. Your images and any wording on the film strip should appear backwards on the side that faces up. Note: When scanning without the scanner cover, gently press down on your document to flatten it. 4. When you are finished scanning, replace the scanner cover. Placing Film or Slides Removing the Document Mat To scan film strips or slides, you need to remove the document mat from the scanner cover. This uncovers the transparency unit window so your scanner can use it to scan your film or slides. Note: Hold the edge of the film gently or use gloves to touch the film; otherwise you may damage the film. Make sure the white stickers on the back of the film holder and the areas around them are not scratched, dusty, or covered in any way. If the areas are obscured, the scanner may have trouble recognizing your film in Full Auto Mode. Do not cover the small holes in the film holder. 4 - Epson Perfection V350 Photo 8/06