Epson WorkForce 630 Start Here - Page 2
Load paper - printer
View all Epson WorkForce 630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Open the cartridge cover. 3 Shake the ink cartridges gently 4 or 5 times, then unpack them. 5 Load paper You can load letter-, A4-, or legal-size paper, as well as 4 6-, 5 7-, or 8 10-inch photo paper. For instructions on loading legal-size paper, see the online User's Guide. 1 Pull out the paper cassette. 4 Remove only the yellow tape from each cartridge. Caution: Don't remove any other seals or the cartridges may leak. 5 Insert the cartridges in the holder for each color. 6 Press each cartridge down until it clicks. 2 Slide the edge guides outward. 3 Position the guide shown below for the size of paper you're using. 4 6-inch Letter-size LTR 4 Insert the paper with the glossy or printable side face- down. 4 6-inch Letter-size 7 Close the cartridge cover. Press down until it clicks. 5 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 4 6-inch Letter-size 8 Lower the scanner. 9 Press the OK button to prime the ink delivery system. This takes several minutes. Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. Caution: Don't turn off the printer while it is priming or you'll waste ink. 6 Gently insert the paper cassette. 7 Extend the output tray as shown.