Epson WorkForce 845 Start Here - Page 2
Load paper - all in one printer
View all Epson WorkForce 845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
4 Remove only the yellow tape from each cartridge. Caution: Don't remove any other seals or the cartridges may leak. 5 Insert the cartridges in the holder for each color. Press each cartridge down until it clicks. 2 Position the guide shown below for the size of paper you're using. Letter- or A4-size 3 Insert the paper with the glossy or printable side facedown. 6 Close the cartridge cover. Press down until it clicks. Then lower the scanner unit. Note: Make sure the paper is loaded against the edge guide and not sticking out from the end of the cassette. 7 Press the OK button to prime the ink delivery system. This takes about 5 minutes. Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. Caution: Don't turn off the printer while it is priming or you'll waste ink. 8 When you see this menu on your product's LCD screen, do not press any buttons yet. Continue following the instructions in the following sections to load paper in your product and install software. 4 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 5 Gently insert the paper cassette. 5 Load paper You can load letter-, A4-, or legal-size paper, as well as 4 × 6-, 5 × 7- or 8 × 10-inch photo paper in cassette 1. In cassette 2, you can load only letter-, A4-, or legal-size plain paper. For instructions on loading photo or legal-size paper, see the online User's Guide. 1 Pull out paper cassette 1. Note: The paper may slide forward slightly as you insert the cassette. This is normal. 6 Follow steps 1 to 5 to load plain paper in cassette 2. Remove the clear plastic cover before loading paper, then replace it after paper is loaded. 7 Extend the output tray as shown.